Search the vast repository of wisdom at Fixitnow.com:
Diagnosing Dishwasher Door Leaks
When diagnosing water leaking from you dishwasher door, you need to determine if the water is coming from inside the door liner, from underneath the door, or out the door gasket. Here a few things to check before pulling out your tool box.
Dishwasher Installation is Critical!
The dishwasher has to be level, with all four legs firmly on the ground, and square. Check the level front to back and side to side. Level is especially critical if your dishwasher has a plastic tub because these can be warped by cruddy installation jobs.
Oversudsing
Gawd, I can't even count how many service calls I've been on leaking dishwashers only to find that the problem was either 1) using too much soap or 2) someone (usually hubby) put in liquid dishwashing soap instead of dishwashing detergent. In either case, the dishwasher will whip up more suds than an overcharged keg in a brewpub and you'll end up with soapy water all over your floor.
Water Overfill
The water level should come up to the bottom edge of the heating element. To check this, open the door after the dishwasher fills with water and starts spraying. If the dishwasher is not level front to back and is pitched forward, the water level will be above the heating element in front but below the element in back.
Door Alignment
The door liner needs to be centered in the door gasket. If it ain't...you guessed it, LEAK!
Door Gasket
Cracks, tears, and shrinkage can all cause a door gasket to leak. Sometimes, on older dishwashers, the gasket can look ok, but the rubber has become age-hardened and so doesn't make a good seal with the cabinet anymore. This is especially true with Kitchenaids.
Lid Latch Grommet
This is the little gasket that seals the latch on the soap door. A common source of leaks with Maytag dishwashers is that this grommet will tear and cause leaks. Easy $2 fix.
Wash Arm
Lots of times, plastic wash arms will split at the seams. This pushes high pressure water directly at the door and out through the gasket. To check the spray arm for splits, run the dishwasher to heat the arm then grab both ends and gently twist, looking for splits.
Front Tub Flange
Sometimes the front tub flange on plastic basins can warp and pucker outward, causing leaks. Use a heat gun or warm up the plastic and bend it back into place.
Well, allllrighty then.
To learn more about your dishwasher, or to order parts, click here.
Your Appliance Guru: