If you have a Whirlpool Cabrio / Kenmore Oasis / Maytag Bravo Washer that’s throwing an OL error code, the problem is most likely a stuck tub. If the tub isn’t free to float, it causes the motor to draw excessive current that generates the OL (over load) error code.

BTW, this problem is usually caused by using non-HE detergent or too much HE detergent in these machines, read more here. The excess detergent residue forms a cement-like gookus that builds up on the drive shaft and sticks to the outer tub. It can also kill the tub bearing in which case you’ll need to replace the entire outer tub assembly because the bearing comes factory assembled into the new tub.

Here’s the part link for the new tub assembly ==> Drum Assembly

To fix the problem, you’ll need to remove the outer tub and clean the gookus off the drive shaft. This Cabrio washer teardown guide will help with that.

The teardown will all go like a breeze until you get to the part where you actually need to pull the tub out of the cabinet. Then the hernias, dislocated spinal disks, and spleen venting begins. Here are some tips that’ll help you get the tub out:

To learn more about your washing machine, or to order parts, click here.