Kenmore Dryer doesn’t dry the clothes very well. Takes 3-4 cycles to do so. Would it be the thermostat or the heating element and where are these located? How do I replace these by myself?
Thanks._______________________________
The above message was sent when you were offline, via your LivePerson site.Message sent from IP: 204.58.103.10
This is one of the most common dryer complaints. The cause is so simple that most grasshoppers don’t believe me when I tell them. Oh, how I valiantly try to explain to them that the problem isn’t the dryer at all, it’s the vent. "But I checked the vent and it’s clear," they reply, incredulously. The Samurai has the cure for your ignorance in his famous dryer venting primer. Knowledge is power!
You may also like...
- War Story: Slow Drying Dryer and Frankenkitty
- Mailbag: Gas Dryer Fires Up But Goes Out After a Few Minutes
- Mailbag: Dryer Thermal Fuses Keep Blowing
- Dryer repeatedly blowing thermal fuses? Here are some things to check.
- Mailbag: Non-Standard Dryer Vent
- Mailbag: Dryer Heats but Drum Won’t Turn
- Dryer Venting Wisdom
- Mailbag: Slow Water Flow into a Washer, Part II
- Mailbag: Dryer keeps blowing thermal fuses
- Mailbag: Maytag Gas Dryer Won’t Fire Up
You must log in to post a comment.