Example model number – ATF7000EG0

READING ERROR CODES:

1. Wake the washer by pressing any button.
2. Wait 5 seconds.
3. Press and HOLD the Start/Pause and Cancel buttons simultaneously.

As long as the buttons are held, the failure code will appear in the display as an E followed by two numbers, a number and a letter or two letters. The control will beep and the Door Lock, Wash, Rinse, and Final Spin indicator lights will flash.

Quick Check

If there is no error displayed and the washer momentarily starts then turns back off:

1. Listen for a relay closure inside the motor control shortly after the Start/Pause key is pressed. If this happens, the motor control has power.

2. Check the 5 pin connector wiring between the console control and the motor control.

NOTE: During normal operation, the display may show:
“SAn” – deep clean (Sanitary Cycle)
“cd” – cool down (Sanitary cycle)
“do” or “dr” – door problem.
“Err” – an error has been detected.
“LOC” – control lock is activated.
“PAU” – cycle has been interrupted.

Samurai Appliance Repair Man

The Samurai Family of Appliance Repair Websites

Parts==> http://parts.fixitnow.com
Forums==> http://appliantology.org
Facebook==> http://facebook.fixitnow.com
Twitter==> http://twitter.fixitnow.com
Newsletter==> http://newsletter.fixitnow.com
SMS==> 603-505-8460