Do-It-Yourself Appliance Repair Help                               
Fixitnow.com Samurai Appliance Repair Man:  Kicking Appliance Butt All Over The Globe!

Appliance repair FAQs

Get interactive repair help from master appliantologists.

Let's finish the job!


Whirlpool Duet Washer Giving Some Not-So-Good Vibrations

by Samurai Appliance Repair Man

Your mother called and said for you to buy all your applaince parts here!  Over 800,000 parts in stock, 98% ship the same day, 30-day no-hassle return policy-- return any part for any reason!

rgterzian wrote

Have a Whirlpool Duet HT Washer Model GHW9200LW0. Dryer stacked using
Whirlpool kit Banging or knocking at low speed spin only, noise stops as spin speed
increases. Minimal vibration in all cycles, unit near perfectly level. Performs
well- clothes clean, undamaged, relatively dry after spin. Can you help me,
wise one?

_______________________________
Message sent from IP: 68.36.210.89

This was a recent topic of discussion in the Samurai Appliance Repair Forums. The problem really boils down to inadequate floor support and harmonic mechanical vibrations set up between the washer during the spin cycle and the floor. Read all about it ratcheer.

Washer Repair FAQs


7 Responses to “Whirlpool Duet Washer Giving Some Not-So-Good Vibrations”

  1. VCorry1@aol.com Says:

    Whirlpool Duet Washer Model ghw9400plo;Multiple breakdowns,Circuit Board after door lock replacement,Now control locked,time to call service again,unit is 7 months old,This upgrade feels like a downgrade due to poor initial dependability.

  2. Samurai Appliance Repair Man Says:

    See this page for instructions on getting out of control lock.

  3. Anonymous Says:

    How about control lock on duet washer? Mine is stuck on control lock and I cant get it off.

  4. Samurai Appliance Repair Man Says:

    Try pulling the plug on the washer for about 15 minutes and plugging it back in. If that doesn’t clear the control lock, then you need to replace the main control board.

  5. Samurai Appliance Repair Man Says:

    For answers to all your Whirlpool Duet ? Kenmore HE3 washer questions, buy the genuine service manual for this washer.

  6. Anonymous Says:

    Hello,

    I just bought a house and it came with a Whirlpool Duet washer which worked the first three times I used it. Now after a cycle finishes, it fills back up with water. I have tried the drain and spin cycle which worked once, but now I can’t get it to do anything. Any suggestions?

    Thanks,

    Kevin

  7. Samurai Appliance Repair Man Says:

    I would put the machine into diagnostic mode to nail down what’s happening. The tech sheet for your washer explains how to do this. It’s cleverly hidden in your washer.

Leave a Reply

You must be logged in to post a comment.